2T computer double column servo tension machine is suitable for testing and analyzing the mechanical properties of rubber, tire, rubber tube, tape, sole, plastic, film, acrylic, FRP, ABS, EVA, PU, aluminum plastic pipe, composite material, waterproof material, fiber, textile, wire and cable, paper, gold foil, tape, silk thread, spring, wood, medical packaging materials, tape, etc., such as stretching, compression, tearing, peeling (both 90 degrees and 180 degrees)< br />
This machine is a new type of material testing machine that combines electronic technology with mechanical transmission. It has high accuracy and sensitivity for the measurement and control of load, deformation and displacement. This series of models adopts a single space structure, with the test space in the lower space. It is mainly applicable to the test of metal and non-metallic materials with the test load less than 2kN. It has a stress, strain and displacement control mode, and can calculate the maximum force, tensile strength, bending strength, compression strength Elastic modulus, elongation at break, yield strength and other parameters< br />
Introduction to Control Software

Software operating system language: Simplified Chinese/English

Force value unit: N, KN, Kgf, Lbf, length unit: mm, cm, in, freely convertible

Automatic zeroing: when the computer receives the command to start the test, the measurement system will automatically reset to zero< br />
Display mode: data and curve are displayed dynamically with the test process< br />
Result reproduction: the test results can be accessed at will and the data curve can be re analyzed< br />
Results comparison: multiple test characteristic curves can be superposed, reproduced, magnified and analyzed by presenting a group of samples with different colors< br />
Emergency stop: emergency stop switch is set to cut off the power supply of the whole machine in emergency state< br />
Control Method:

  Computer software sets speed, load break (break), running time and other control modes

  Automatically judge material fracture, crushing, etc. and automatically stop the machine. Automatic return can be set

Curve type:

  Load displacement, load time, displacement time< br />
  Stress strain, strain time, stress time< br />
 & nbsp; The vertical and horizontal coordinates of the curve can be set arbitrarily< br />
Available test data:

  Maximum strength, minimum strength, breaking value, upper and lower yield strength, tensile strength, compressive strength, elastic modulus, elongation, maximum, minimum and average values of stripping interval, etc. With overload, overcurrent, overvoltage, undervoltage, overspeed, stroke and other multiple protection< br />
  The data results are exported from the crystal report format currently adopted by the national standard< br />
Technical parameters:

Capacity selection: 500kg sensor, American high-precision load cell

Accuracy level: 1.0

Effective force measuring range: 0.4%~100%

Force measuring accuracy:± Within 0.5%

Resolution of testing machine: maximum load 1/± 250000 yards, no internal and external grading, and the whole range resolution remains unchanged

Load cell

Basic configuration: tension and compression sensors (maximum load)

Effective test width: 380mm

Effective stretching space: 800mm (excluding clamps)

Test speed range: 50~480mm/min

Displacement measurement accuracy:± Within 0.5%

Test bench safety device: electronic limit protection

Test bench return function: manual or automatic selection, automatic or manual return to the initial test position after the test

Overload protection: if the maximum load exceeds 10%, the machine will be automatically protected

Fixture configuration: a set of stretching clamps

Host size: 700× 600× 1800mm

Motor: 220V± 10% 0.37KW  Funeng precision machine frequency conversion motor

Transmission mechanism: high-precision ball screw

Host weight: (about) 200 Kg